DEMAG DRC-10 Operating Instructions Manual page 38

No. Problem
The displayed crane
08
does not respond
The displayed crane
09
does not respond
The displayed crane
10
does not respond
Crane does not respond
11
to key command
The crane identifi cation
12 displayed on the trans-
mitter is incorrect
The crane identifi cation
13
is missing in the display
Hand-held transmitter
14 does not respond to
key actuation
The batteries are not
15
being charged
1) Additional symbols in the display fi eld are possible
38
Indicators Possible causes
1)
K123 ???
Another hand-held transmitter
has been logged on for the crane
LED Green, flashes
1)
K123 ???
Power supply of receiver
interrupted
LED Red
K123 ??? 1)
Crane receiver outside range of
transmitter
LED Green, flashes
1)
K123 ???
Stop
STOP mode
LED Red
1)
NOID
The crane identifi cation of the
receiver was changed with the
hand-held transmitter
LED Green, flashes
1)
The crane identifi cation of the
receiver was changed with the
hand-held transmitter
LED Green, flashes
Any malfunctioning
Software crash
display
Hand-held transmitter is switched
off
LED Off
Notes, section in this document
Take the other hand-held
transmitter out of service, 7.3.
Log-on hand-held transmitter
again, 6.2.2.
Actuate STOP key, then enter
On key, 7.2.1. No. 06 or 10 is
then possible.
Reduce distance to crane, 2.7
and 5.2.1 Check radio reception
by means of log-on procedure
6.2.2. Check aerial connector on
receiver.
Enter On key, 7.2.1.
Safety problem! A crane that is
not displayed is being controlled.
Actuate signal to identify the crane.
Log-on hand-held transmitter, 6.2.2
Safety problem! A crane that is
not displayed is being controlled.
Actuate signal to identify the crane.
Log-on hand-held transmitter, 6.2.2
Reset hand-held transmitter, 7.4.5.
Then switch on with STOP.
Switch on with STOP key, 8.2.
01 is then possible