DEMAG DRC-10 Operating Instructions Manual page 24

24
Following activation, a two-digit number is shown in the first main row which
indicates the number radio receivers that can be controlled and are within range.
(In the example, 01 controllable receiver is shown.)
Select radio receiver based on crane identification
End search
8
Press 1 x
After starting selection with F1, the crane identification of the controllable radio
receivers can be displayed one by one by scrolling with the Left and Right keys
Confirm
10
Confirm 1x
By pressing the F2 key for confirmation, the hand-held transmitter is assigned to
the DRC-MP or DRC-DR radio receiver whose crane identification is shown in the
second main row of the display (NOID in the example). At the same time, the crane
identification of the DRC-10 hand-held transmitter is also changed to the new
value and displayed next to the battery icon.
Log-on of the hand-held radio transmitter is then completed by actuating the Lift
key.
Note: Log-on of the DRC-10 hand-held transmitter to a DRC-MP or DRC-DR
radio receiver with code NOID is only necessary when the unit is put
into operation for the first time in order to assign the crane identification
determined in section 6.2.3 to the receiver.
Select
42675344.eps
NOID
0 1
NOID
42675444.eps
Select crane/travelling
hoist
42678744.eps
42694444.eps