Putting The Radio Control System Into Operation After Installation; Putting Into Operation; Putting A Radio Remote Control System With Drc-10 Into Operation - DEMAG DRC-10 Operating Instructions Manual

6 Putting the radio control system into operation after
installation

6.1 Putting into operation

6.1.1 Charging the batteries before
putting the unit into operation
for the first time
6.1.2 Assembly and connection of
the radio receiver
6.1.3 Applying the crane
identification on the crane
6.2 Putting a radio remote
control system with
DRC-10 into operation
6.2.1 Switching on the hand-held
transmitter
22
A radio control system has been put into operation when the hand-held transmitter
has been put into operation. The following preparation measures are necessary:
The scope of delivery of the DRC-10 hand-held transmitter includes a separate
rechargeable battery. It must be inserted in the battery compartment of the hand-
held transmitter ensuring the correct pole arrangement (see also inllustration in
section 7.4.5).
Since new rechargeable batteries are only partially charged, they must be charged
before the unit is put into operation for the first time by connecting them to the
plug-in charger (see section 8.2).
If no battery icon is displayed when the hand-held transmitter is activated,
the batteries are completely discharged. In this case, the batteries must be
charged in the enclosed plug-in charger.
Demag DRC-MP or DRC-DR radio receivers must be fitted in accordance with the
relevant operating instructions and connected in accordance with the circuit dia-
gram of the installation. Comply with the instructions and measures described in
the operating instructions for putting the radio receiver into operation.
A unique crane identification/number must be selected (recommended: a 3-figure
number) and fitted to the crane in accordance with section 5.3 for the crane fitted
with the radio control system.
Following these preparation measures, put the hand-held transmitter into operation
by logging it on to the radio receiver of the crane to be controlled. Following this
procedure, the radio control system is configured for the specific application.
The Demag DRC-MP or DRC-DR radio receiver on the crane must be supplied
with power, be ready for operation and within the range of the hand-held transmit-
ter.
When the unit is switched off, there are no icons in the display, the LED is off. To
switch on the hand-held transmitter, actuate the Stop key.
2
Red
1
Press 1 x
The DEMAG logo is displayed first. The DRC-10 hand-held transmitter scans the
radio channels for controllable radio receivers and searches for an assigned radio
receiver. Before the hand-held transmitter has been put into operation for the first
time, it has no radio receiver assigned, therefore you can expect the following
display:
42674644.eps
NOID ???
42694244.eps