Table of Contents
Advertisement
Icons in the first main row
Load-proportional bar display
Fault icon
The fault icon is displayed in the event of a fault.
The code of the fault is displayed in the row below. If there are several
faults at the same time, the code displayed changes in cycles.
Overload icon
The overload icon is displayed in the event of an overload. The load of the
selected travelling hoist(s) is also displayed in the row below if the hoist is
fitted with ZMS.
Brake icon
The brake icon is displayed, if the additional brake has been applied.
"Universal output 1 switching status" icon
This icon is displayed when universal output 1 is active. The function of
this output can be programmed.
"Universal output 2 switching status" icon
This icon is displayed when universal output 2 is active. The function of
this output can be programmed.
"Attention! Safety function de-activated" icon
This icon indicates that a function relevant for safety such as load reduc-
tion or by-pass control has been de-activated by the operator.
"Load reduction active" icon
The icon indicates that load reduction is active. As long as load reduction
is active, only the reduced load (specified by a parameter) can be lifted.
The load-proportional bar display shows the load on the crane in five
increments of approx. 20 %. This display is independent of the travelling
hoist selection and always refers to the max. possible load.
19
Hide quick links:
Advertisement
Table of Contents
