Table of Contents
Advertisement
7.4.4 Standby mode
7.4.5 Resetting the hand-held
transmitter
30
The display shows the lock icon. No radio connection is displayed. In standby
mode, power consumption of the transmitter is strongly reduced and the radio con-
nection is de-activated.
The operator can switch on Standby mode by using the switch-off procedure, sec-
tion 7.3, and by plugging-in the charger.
Standby is automatically switched on by the timeout function as described in sec-
tions 7.4.2 and 7.4.3.
The operator can end Standby mode only by entering the On key, section 7.2.1,
and then change to Run mode.
A reset of the hand-held transmitter may become necessary in the case of error
statuses of the software.
The hand-held transmitter can be reset by removing a battery for a short time.
The batteries can be reached by carefully pulling off the lower rubber cap:
Pull off rubber cap.
When changing the battery,
note pole arrangement of the
transmitter.
42661144.eps
42745144.eps
Hide quick links:
Advertisement
Table of Contents
