DEMAG DRC-10 Operating Instructions Manual page 25

6.2.3 Assignment of crane
identification/number for
the radio receiver
Important! The assignment of the crane identification described in the following
for putting the radio receiver into operation is a safety-relevant proc-
ess that may only be carried out by authorized expert personnel.
After successful establishment of a radio connection between the DRC-10 hand-
held transmitter and the DRC-MP or DRC-DR radio receiver, the crane identifica-
tion determined acc. to section 5.3 must be assigned to the radio receiver. As long
as the radio receiver operates with code "NOID", no movement commands are
output to the crane control system. (To check radio transmission in this status, use
the signal key if Run mode has been activated.)
Activating the assignment
Assignment is activated in STOP mode or Run mode.
• Actuate and hold down the STOP key
• Actuate the Lower key
• Actuate the Right key twice
• Hold down the Lower key for 5 seconds, until the display changes
• Release the Lower key
• Release the STOP key
The following display appears
Note: Additional information may also be shown in the display depending on
the type of crane control system.
The code no. of the displayed parameter is shown in the first main row.
The value of the parameter is shown in the second main row.
Selection of parameter 004 for the crane identification/number
• Right key
• Left key
Entry of the crane identification/number
First select parameter 004, then actuate the F1 key to start entry. The following
display appears
NOID
001:
000
increases the displayed code no.
decreases the displayed code no.
NOID
- - - -
42694544.eps
42694644.eps
25