Table of Contents
Advertisement
2.5 Safety instructions
for installation and
disassembly
10
The system must be taken out of service immediately if functional defects or
irregularities are detected.
In the event of a stoppage (e.g. if defects regarding safe and reliable operation
are detected, in emergency situations, in the event of operating malfunctions, for
maintenance purposes, if damage is detected or after finishing work), the operator/
experienced technician must carry out all prescribed safety measures or observe
that they are automatically carried out.
Personal protective clothing must be worn as necessary or as required by regula-
tions. Personnel must not wear loose clothing, jewellery including rings or long
hair loose. Injury may occur, for example, by being caught or drawn into the
mechanism.
All safety and hazard warnings on the product, its access routes and mains
connection switches must be preserved completely and in legible condition.
Modifications, additions to and conversions of the product which might impair
safety in any way must not be carried out without the approval of Demag.
Safety devices must not be rendered inoperative.
Only genuine Demag spare parts may be used. Observe prescribed deadlines
or those specified in the operating instructions for routine checks/inspections.
• Installation and disassembly work may only be performed by experienced
technicians.
• Installation and disassembly work must be co-ordinated by the person carrying
out the work and the owner within the scope of their responsibility.
• The assembly zone must be made safe.
• The installation must be isolated in accordance with the relevant electrical
regulations.
• Customer-specific regulations must be observed.
• Only appropriate, tested and calibrated tools may be used.
In the case of disassembly, any waste material must be disposed of by the owner
in an environmentally compatible way in compliance with the valid regulations.
Hide quick links:
Advertisement
Table of Contents
