DEMAG DRC-10 Operating Instructions Manual page 23

6.2.2 Log-on of hand-held
radio transmitter
2
Red
1
Press
1 x
42674644.eps
If the transmitter has already been assigned to a receiver in the log-on steps as
described in section 6.2.2, you can expect the following display:
In this case, continue putting into operation with the assignment of the crane
identification, see section 6.2.3.
Note: Additional information may also be shown in the display depending on
the type of crane control system.
Logging on hand-held transmitter as described in the following is a safety-relevant
process that may only be carried out by authorized and instructed expert person-
nel.
Important:
Each receiver is assigned a crane identification when it is put into service (see
section 6.2.3).
This crane identification must be shown in a clearly visible manner on the travel-
ling hoist or crane by means of coding labels. When a new hand-held transmitter is
logged on, the crane identification shown on the hand-held transmitter must match
the coding labels on the crane (see section 5.3).
Correct assignment between the transmitter and the crane must be checked by
actuating the horn before any crane motion is actuated.
If the correct assignment is not checked, unintended crane movements may cause
serious damage and injuries, even resulting in death.
Log-on of a DRC-10 hand-held transmitter to a DRC-MP or DRC-DR radio receiver
establishes the assignment between the relevant hand-held transmitter, the con-
trolled radio receiver and the crane that is unique world-wide. The transmitter and
the receiver are provided with unique address features that are exchanged during
the log-on process and ensure clear and unique assignment. During the log-on
steps, the crane identification (see sections 5.3 and 6.2.3) is also transmitted from
the receiver to the hand-held transmitter and is saved. DRC-10 hand-held trans-
mitters show this crane identification/number so that the operating personnel can
identify the controlled crane.
Log-on is activated in Run mode or STOP mode.
Hold down for approx.
5 seconds
4
Press
3 x
3
42675044.eps
NOID
STOP
5
Hold down
???
7
6
1)
01
42675144.eps
42694344.eps
Red
42676344.eps
23