Displaying And Entering The Max. Quick Charging Time, Parameter Code 007; Frequency Hopping - DEMAG DRC-10 Operating Instructions Manual

1.9 Displaying and enter-
ing the max. quick
charging time,
Parameter code 007
1.9.1 Display mode
1.9.2 Entry and selection mode
1.9.3 Selection of figures
1.9.4 Changing to the next position
1.9.5 Confirming the new value
1.9.6 Exiting the menu

1.10 Frequency hopping

1.10.1 Downward compatibility with
older receivers
46
This parameter defines the time (in minutes) after which the hand-held transmitter
ends quick charging at the latest.
The default value set in the factory is a time period of 100 minutes. This time is
rated for rechargeable batteries with a capacity of max. 2100 mAh. If rechargeable
batteries with a higher capacity are to be used, the max. quick charging time must
be adapted.
The current time period is shown in the display. To navigate, use the following
keys:
Key Function
Right Change to display of parameter 001
Left Change to display of parameter 006
Lift Exit parameter programming menu
F1 Change to entry and selection mode
After changing to entry mode, the colon following the parameter code 007 is re-
placed by an equals symbol. Instead of the current value, the character string
"0——" is displayed. Entry starts with the first character on the left.
Use the Left and Right keys to select the character for the current position. Only
figures 0 – 9 may be used.
Change to the next position by actuating the F1 key.
Following complete, correct entry, confirm the new value by actuating the F2 key.
Entry and the Hand-held transmitter parameter programming menu can be exited
by actuating the Lift key at any time. The parameter will remain unchanged, if the
Lift key is actuated before the entered value has been accepted with F2.
DRC-10 hand-held transmitters operated with the frequency hopping method
can also be combined with older receivers not featuring the frequency hopping
method.
In this case, set the DRC-10 hand-held-transmitter to "Locked frequency opera-
tion", see chapter Programming the parameters of the DRC-10 hand-held trans-
mitter, section 1.6: Displaying and entering a fixed frequency channel.
The display of the DRC-10 hand-held transmitter shows whether it is a frequency
hopping transmitter or not, see figure below.
Transmitter without frequency hopping
NOID
Transmitter with frequency hopping
NOID ???
42718344.eps 42718244.eps