Configuration Of A Radio Remote Control System For Drc-Dr - DEMAG DRC-10 Operating Instructions Manual

6.3 Configuration of a
radio remote control
system for DRC-DR
26
Four free digits for entry of the crane identification/number are highlighted in the
first main row. The first digit is preselected. Use the right and left keys to select a
number/character from the available set of characters. Press the F1 key to accept
the selected character and to change to the next position.
Transmitting the assigned crane identification
When the appropriate crane identification has been entered, press the F2 key to
confirm and to transmit it to the crane receiver. This crane identification is then
saved in the radio receiver. The hand-held transmitter will keep and display its old
crane identification (NOID) until the hand-held transmitter has been logged on for
the radio receiver with the new crane identification as described in 6.2.2.
NOID
STOP
Cancelling/ending assignment of the crane identification
The entry can be cancelled at any time without changing the crane identification by
actuating the Lift key. Entry is completed by actuating the F2 key. Then use the Lift
key to exit the assignment menu.
Important! After changing the crane identification for the receiver, log-on of the
hand-held transmitter must always be carried out (section 6.2.2) so
that the new crane identification is displayed on the hand-held trans-
mitter.
DR cranes that are provided with the DRC-DR radio receiver use an extended
scope of functions of the DRC-10 hand-held transmitter for configuration of the
crane control system and to display information. Additional instructions and infor-
mation are described in the operating instructions of the Demag DRC-DR radio
receiver (ident. no. 214 953 44) for putting a crane with the DRC-DR radio receiver
into operation.
???
42694344.eps