Menu For Programming The Hand-Held Transmitter; Activating The Menu; Displaying The Current Parameters; Displaying The Serial Number Of The Hand-Held Transmitter, Parameter Code 001 - DEMAG DRC-10 Operating Instructions Manual

1

Menu for programming the hand-held transmitter

1.1 Activating the menu

1.2 Displaying the current
parameters
1.3 Displaying the serial
number of the hand-
held transmitter,
Parameter code 001
42
The "Hand-held transmitter parameter programming" menu can be used by
specially trained personnel for displaying and partly changing the following
settings of the hand-held transmitter:
Code Information
001 Display of the serial number of the hand-held transmitter,
002 Display of the software version of the hand-held transmitter,
003 Display of the hardware version of the hand-held transmitter,
004 Display and entry of a fixed frequency channel (channel lock),
005 Display and entry of the cut-out time in STOP mode,
006 Display and entry of the cut-out time in Run mode,
007 Display and entry of the max. quick charging time,
Note: Parameters 004 to 007 are set in the factory and must not be changed
without prior agreement.
Attention: Changes to the parameters of the hand-held transmitter may impair
functioning of the hoist unit.
The menu is activated in Run mode or STOP mode.
• Actuate and hold down the Stop key
• Actuate the Lift key
• Actuate the Left key twice
• Actuate the Lift key again and hold it down for approx. 5 seconds
• Release the Lift key again
• Release the Stop key
Every change to the „Hand-held transmitter parameter programming" menu is
signalled to the crane control system.
Only parameters are first displayed after activation of the menu. The display starts
with parameter 001, i.e. the serial number of the hand-held transmitter:
+
00066145
Use the Right and Left keys to select the parameter to be displayed. The menu
can be exited with the Lift key at any time.
The serial number of the hand-held transmitter is displayed with parameter 001.
It is only provided for information and cannot be changed. To navigate, use the
following keys:
Key Function
Right Change to display of parameter 002
Left Change to display of parameter 007
Lift Exit menu
K564
001:
42694744.eps