Configuration Of A Radio Control System For Drc-Dr - DEMAG DRC-MJ D3 User Manual

7.7 Configuration of a
radio control system
for DRC-DR
32
Entry of the crane ID/number
First select parameter 004, then press the F1 key to start entry. The following
screen appears:
4 free digits for entry of the crane ID/number are highlighted in the second main
row. The first digit is preselected. Use the RIGHT and LEFT buttons to select a
number/character from the available set of characters.
Press the F1 key to accept the selected character and to change to the next
position.
Transmitting the assigned crane ID
When the appropriate crane identification has been entered, press the F2 key to
confirm and to transmit it to the DRC radio receiver. This crane identification is
then saved in the DRC radio receiver. It is shown on the upper row of the screen
(for example, 0001).
Cancelling/ending assignment of the crane ID
The entry can be cancelled at any time without changing the crane identification by
pressing the LIFT button.
DR/DMR cranes that are equipped with a DRC-DR radio receiver use an extended
scope of functions on DRC-MJ D3 hand-held transmitters. They are used to
configure the crane control system and to display information.
Additional instructions and information are described in the DRC-DR radio receiver
user manual/assembly instructions (ident. no. 211 267 44) for putting a crane into
operation if it is equipped with a DRC-DR radio receiver.
NOID
004=
−−−−
0001
STOP
43614044.eps
43614144.eps