9927-2Stoh Rear I/O Modules; Technical Specifications - Cobalt Digital Inc 9927-2StoH Product Manual

Introduction

9927-2StoH Rear I/O Modules

Technical Specifications

Table 1-1 Technical Specifications
Item
Part number, nomenclature
Power
Installation/usage environment
Installation Density
Environmental:
Operating temperature:
Relative humidity (operating or storage):
Frame communication
Standards Supported
SDI Inputs
HDMI Outputs
9927-2STOH-OM (V1.0)
The 9927-2StoH physically interfaces to system video connections at the rear
of its frame using a Rear I/O Module.
All inputs and outputs shown in the 9927-2StoH Functional Block Diagram
(Figure 1-1) enter and exit the card via the card edge backplane connector.
The Rear I/O Module breaks out the 9927-2StoH card edge connections to
coaxial and other connectors that interface with other components and
systems in the signal chain.
The full assortment of 9927-2StoH Rear I/O Modules is shown and described
in 9927-2StoH Rear I/O Modules (p. 2-4) in Chapter 2, "Installation and
Setup".
Table 1-1 lists the technical specifications for the 9927-2StoH card.
9927-2StoH 3G/HD/SD Dual-Channel openGear
Converter with Per-Channel Frame Sync
37 Watts
Intended for installation and usage in frame meeting openGear™
modular system definition
Up to 7 cards per 20-slot frame as follows:
• OG3 Frame: (5) cards
• HPF-9000 Frame: (5) cards
• oGx Frame: (7) cards
32° – 104° F (0° – 40° C)
< 95%, non-condensing
10/100/1000 Mbps Ethernet with Auto-MDIX
SMPTE 259M, 292M, 424M (10-bit video processing)
(2) 75Ω 3G/HD/SD-SDI Inputs
(2) HDMI 2.0; Type A (standard) connectors
9927-2STOH PRODUCT MANUAL
Technical Specifications
Characteristic
®
HDMI-To-SDI
1-13