Installing an SFP+ Transceiver
Installing an SFP+ Transceiver
This switch supports only Brocade-qualified transceivers. For current information on qualified transceivers supported by this device, refer
to the "Brocade Fibre Channel Transceiver Platform Support Matrix" and applicable transceiver data sheets on www.broadcom.com. If
you use an unqualified transceiver, the switchshow command output shows the port in a Mod_Inv state. Fabric OS also logs the issue in
the system error log.
To insert an SFP+ transceiver, complete the following steps:
Brocade 7810 Extension Switch Hardware Installation Guide
54
7810-IG101