ZyXEL Communications PMG2006-T20A User Manual page 26

PPPoE Service Name
Static IP Address
Others
Select Enable in the Active field. Enter the General and Account Information settings as provided
3
above.
Choose the Encapsulation specified by your DSL service provider. For this example, the service provider
requires a username and password to establish Internet connection. Therefore, select PPPoE as the WAN
encapsulation type.
Set the IPv6/IPv4 Mode to IPv4 Only.
Enter the account information provided to you by your DSL service provider.
4
Configure this rule as your default Internet connection by selecting the Apply as Default Gateway check
5
box. Then select DNS as Static and enter the DNS server addresses provided to you, such as 192.168.5.2
(DNS server1)/192.168.5.1 (DNS server2).
Leave the rest of the fields to the default settings.
6
Click Apply to save your settings.
7
Chapter 4 Tutorials
MyGPON
192.168.1.32
Authentication Method: AUTO
PPPoE Passthrough: Disabled
NAT: Enabled
IGMP Multicast Proxy: Enabled
Apply as Default Gateway: Enabled
VLAN: Disabled
PMG2006-T20A User's Guide
26