Functional Tests - Emerson Rosemount 3051S Reference Manual

Reference Manual
00809-0100-4804, Rev AA
January 2011

FUNCTIONAL TESTS

Fast Keys
Find Device
Fast Keys
Figure 4-1. "Find Device"
Pattern
The Loop Test command verifies the output of the 3051S ERS system, the
integrity of the 4-20 mA loop, and the operations of any recorders or similar
3, 5, 5
devices installed in the loop.
To perform a Loop Test, follow the procedure below:
1. Connect a reference meter to the 3051S ERS system by either
connecting the meter to the test terminals on the terminal block of the
ERS Primary sensor or shunting power through the meter at some point
in the loop.
2. Launch the Loop Test function using AMS or a Field Communicator.
3. When prompted, select a mA value to have the ERS system output on
the 4-20 mA loop.
4. Check the reference meter installed in the test loop to verify and
compare the reading to the expected mA output of the ERS system.
a. If the values match, the ERS system and the loop are configured and
functioning properly.
b. If the values do not match, the reference meter may be attached to
the wrong loop, there may be a fault in the wiring, the ERS system
may require an analog output trim, or the reference meter may be
malfunctioning.
The Find Device function causes the ERS system to flash a unique pattern of
characters (Figure 4-1) on the LCD display, making the system easily
1, 7
identifiable in person. The Find Device function requires a digital display to be
installed on the ERS Primary sensor.
0 - 0 - 0 - 0
To run the Find Device function, follow the procedure below:
1. Launch the Find Device function using AMS or a Field Communicator.
2. The ERS system will continue to display the pattern shown in Figure 4-1
until the Find Device function is stopped. Note that it may take up to 60
seconds for the ERS display to return to normal operation upon
completion of the Find Device function.
Rosemount 3051S ERS System
4-7