Siemens SIMATIC IPC277D Operating Instructions Manual page 99

Procedure
Note
If you want to install the operating system on a data carrier connected to a data carrier
controller unknown to the operating system, you have to integrate the driver of the data
carrier controller. Integrate this driver before starting the partitioning of the data carrier and
installing the operating system, see Section "Information for systems with data carrier
controller".
1. Make sure that the partition on which you want to install the operating system is large
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies, depending on the operating
system, how much RAM you have available and how much additional software you want
to use. Information on how the data carrier is partitioned in its factory state is available in
the following tables.
2. Select the partition on which you want to install the operating system.
3. Click "Next".
Installation is started.
Examples of partitions in the factory state
Windows 7 32 bit:
Partition
First
Second
Information for systems with data carrier controller
Data carrier controllers unknown to the operating system must be made known to the
operating system prior to installation in the "Install Windows" installation program.
Requirement
You have copied the relevant controller driver to a USB stick.
Procedure
1. Connect the USB stick with the controller driver to the device.
2. Start the "Install Windows" installation program as described above.
3. Select "Load Drivers" in the Windows installation window.
4. Select the respective driver on the USB stick.
SIMATIC IPC277D
Operating Instructions, 12/2016, A5E03409486-AE
Name
SYSTEM
DATA
Size File system
25 GB NTFS not compressed
Remainder NTFS not compressed
Device maintenance and repairs
8.4 Installing the software
99