Chapter 8 Setting Up Xenserver; Setting Up The Fibre Channel Cards; For Primergy; For Fujitsu Emulex Fibre Channel Cards - Fujitsu ETERNUS AF Configuration Manual

Chapter 8
Setting Up XenServer
Set up XenServer to connect the ETERNUS DX/AF.
The settings described in this chapter are performed using Citrix XenCenter applications. Prepare a XenCenter
environment before setting up XenServer. For details on how to install and operate XenCenter, refer to the
Citrix documents.
The screenshots in this manual were captured using XenCenter version 5.5.0.
8.1

Setting Up the Fibre Channel Cards

Perform Fibre Channel card settings.
8.1.1

For PRIMERGY

The required procedures vary depending on the Fibre Channel card product ID. For Fujitsu Emulex Fibre Chan-
nel cards, refer to
nel cards, refer to
8.1.2

For Fujitsu Emulex Fibre Channel Cards

This section explains how to install Emulex Fibre Channel cards in the XenServer host and how to connect the
ETERNUS DX/AF.
Log in to the XenServer network or use the Console function of XenServer to perform settings.
For the installation procedure and functions regarding XenCenter, refer to the manuals that can be obtained
on the following Citrix web-site:
https://www.citrix.com/support/
Since the standard driver that is supplied with the OS is used for the Fibre Channel driver, other drivers do
not need to be installed.
Use the following procedure to set the drive parameters.
Use the OneCommand Manager Command Line Interface or the HBAnyware Command Line Interface
•
that are installed in XenServer as standard to set the driver parameters. For mode details, refer to help.
Set the parameters without the ETERNUS DX/AF connected.
•
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix
"8.1.2 For Fujitsu Emulex Fibre Channel Cards" (page
"8.1.3 For Fujitsu QLogic Fibre Channel Cards" (page
Copyright 2017 FUJITSU LIMITED
19). For Fujitsu QLogic Fibre Chan-
21).
19
® ®
XenServer
P3AM-4572-19ENZ0