Replacing The Chip Unit And Refilling Ink - Epson SureColor F6370 User Manual

• If fluid enters your eyes, rinse them immediately with water. Failure to observe this precaution could
result in bloodshot eyes or mild inflammation. If problems persist, consult with a physician.
• If fluid enters your mouth, consult with a physician.
• If swallowed, do not induce vomiting and consult with a physician immediately. Inducing vomiting may
cause material to get in your windpipe and cause injury.
Parent topic:

Replacing the Chip Unit and Refilling Ink

Follow the steps here to replace the chip unit and refill the ink in your product.
1. When the message Check Ink Levels appears on the control panel screen, check how much ink is
left in the ink tank.
If the remaining ink level is above the top edge of the metal plate or greater than 1.9 in. (50 mm) from
the base of the ink tank, continue to use the printer until the remaining ink level is below the top edge
of the metal plate or less than 1.9 in. (50 mm) from the base of the ink tank so that you can use all
the ink in a new ink pack to refill the ink tank.
If the remaining ink level is 1.9 inches (50 mm) or less, go to the next step.
Note: When the message Refill Ink Tank is displayed on the control panel screen and the
remaining ink level is above the top edge of the metal plate or greater than 1.9 in. (50 mm) from the
base of the ink tank, it is time to replace the ink tank. The ink tank must be replaced because fine
dirt, dust, and other foreign material may cause the ink tank's filter to malfunction. The ink tank
Replacing the Ink and Chip Unit
70