ABB 650 series ANSI Engineering Manual page 80

Section 6
Local HMI engineering
74
LED operation mode Follow-F
R
Y
G
R
Y
G
Illumination => = Steady
IEC08000396 V1 EN
Figure 46: LHMI: LED operation mode Follow-F
This is the same mode as Follow-S but the LED illuminates flashing, see
This mode may be used to indicate that a tap changer or Petersen coil is moving.
LED operation mode LatchedAck-F-S
R
Y
G
R
Y
G
Ack
Illumination => = Steady
IEC08000397 V1 EN
Figure 47: LHMI: LED operation mode LatchedAck-F-S / Base
The classical mode to indicate incoming alarms or warnings, which the operator has
not seen since the last acknowledgement, is presented in
mode. Two possibilities for the operator to acknowledge:
• The signal is already gone when acknowledged, the LED turns OFF (at least for
this color).
• The signal is still ON, the LED stays illuminated and changes to steady state.
= Flash
IEC08000396.vsd
= Flash
IEC08000397.vsd
1MRK 511 245-UUS -
Figure 46.
Figure 47 as a basic operation
650 series ANSI
Engineering Manual