Table of Contents
Advertisement
1MRK 511 245-UUS -
5.1.8
650 series ANSI
Engineering Manual
IEC09000613 V2 EN
Figure 37:
ACT: HW signal channels
Validation
Validation checks the application configuration on errors about the rules and
restrictions defined for doing a MainApplication on three levels.
•
During creating the logic while doing a connection or placing a function block.
•
On demand by starting the validation.
•
When writing the application configuration into the IED.
Validation when creating the application configuration
Validation is made when creating the application configuration, for example:
Protection and control engineering
IEC09000613-2-en.vsd
Section 5
61
Advertisement
Table of Contents
