Transporting; Leaving The Driving Position; Slopes; Blocked Cutting Units - Ransomes Super Certes 51 Safety, Operation & Maintenance Manual

• When the machine is to be parked, stored or left unattended, lower the cutting units or apply the
transport latches.
• While mowing, always wear substantial footwear and long trousers. Do not operate the equipment
when barefoot or wearing open sandals.
• After striking a foreign object Inspect the lawnmower for damage and make repairs before restarting
and operating the equipment.
• If the machine starts to vibrate abnormally, check immediately.
3.1.5

TRANSPORTING

• Ensure that the cutting units are securely fastened in the transport position. Do not transport with
cutting mechanism rotating.
• Drive the machine with due consideration of road and surface conditions, inclines and local
undulations.
• Sudden decelerating or braking can cause the rear wheels to lift.
• Remember that the stability of the rear of the machine is reduced as the fuel is used.
3.1.6

LEAVING THE DRIVING POSITION

• Park the machine on level ground.
• Before leaving the driving position, stop the engine and make sure all moving parts are stationary.
Apply brakes and disengage all drives. Remove the starter key.
3.1.7

SLOPES

TAKE EXTRA CARE WHEN WORKING ON SLOPES
• Local undulations and sinkage will change the general slope. Avoid ground conditions which can cause
the machine to slide.
• Keep machine speeds low on slopes and during tight turns.
• Sudden decelerating or braking can cause the rear wheels to lift. Remember there is no such thing as
a "safe" slope.
• Travel on grass slopes requires particular care.
IMPORTANT: When working on any slope select weight transfer, Adjust to provide adequate traction.
3.1.8

BLOCKED CUTTING UNITS

• Stop the engine and make sure all moving parts are stationary.
• Apply brakes and disengage all drives.
• Release blockages with care. Keep all parts of the body away from the cutting edge. Beware of energy
in the drive which can cause rotation when the blockage is released.
• Keep other people away from the cutting units as rotation of one can cause the others to rotate.
3 SAFETY INSTRUCTIONS
en-9