Operating Procedure - Ransomes Super Certes 51 Safety, Operation & Maintenance Manual

7.3

OPERATING PROCEDURE ________________________________________

1. Under no circumstances should the engine be started with the operator presence system engaged.
2. Do not operate the machine or attachments with loose, damaged or missing components.
Whenever possible mow when grass is dry.
3. First mow in a test area to become thoroughly familiar with the operation of the machine and control
levers.
NOTE: To prevent damage to the reel and bottom blade never operate the reel when they are not
cutting grass. Excessive friction and heat will develop between the bottom blade and reel
and damage the cutting edge.
4. Study the area to determine the best and safest operating procedure. Consider the height of
the grass, type of terrain, and condition of the surface. Each condition will require certain
adjustments or precautions.
5. Never direct discharge of material toward bystanders, nor allow anyone near the machine while in
operation. The owner/operator is responsible for injuries infl icted to bystanders and/or damage to
their property.
6. Use discretion when mowing near gravel areas (roadway, parking areas, cart paths, etc.). Stones
discharged from the implement may cause serious injuries to bystanders and/or damage the
equipment.
7. Disengage the drive to the reel and raise the front of the machine when crossing paths or roads.
Look out for traffic.
8. Stop and inspect the equipment for damage immediately after striking an obstruction or if the
machine begins to vibrate abnormally. Have the equipment repaired before resuming operation.
CAUTION
To Help Prevent Injury, Always Wear Safety
Glasses, Leather Work Shoes Or Boots, A
Hard Hat And Ear Protection.
CAUTION
Pick up all debris you can nd before
mowing. Enter a new area cautiously
Always operate at speeds that allow you to
have complete control of the machine.
WARNING
Before You Clean, Adjust, Or Repair This
Equipment, Always Disengage All Drives, Engage
Parking Brake, Stop Engine And Remove Key
From Ignition Switch To Prevent Injuries.
7 OPERATION
en-35