12.38
Checking the frame
12.39
Checking the swingarm
12.40
Checking throttle cable routing
12 SERVICE WORK ON THE CHASSIS
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining
screws, chassis
Remaining nuts,
chassis
F00322-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracks and deformation.
»
If the frame exhibits cracks or deformation due to a
mechanical impact:
–
Change the frame.
S01339-01
–
Check the swingarm for damage, cracking, and deformation.
»
If the swingarm shows signs of damage, cracking, or
deformation:
–
Change the swingarm.
S01340-01
Preparatory work
–
Remove the air filter box cover. (
–
Remove the seat. (
–
Remove the right side cover. (
–
Remove the fuel tank.
M6
M6
Info
Always replace a frame that has been
damaged due to a mechanical impact. Repair
of the frame is not authorized by Husqvarna
Motorcycles.
Info
Always change a damaged swingarm. Repair
of the swingarm is not authorized by Husq-
varna Motorcycles.
p. 69)
p. 68)
p. 74)
(
p. 74)
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
p. 56)
83