Adjusting The Idle Speed - Husqvarna TE 250i Owner's Manual

17 TUNING THE ENGINE
17.4
126
102246-10
V00969-10

Adjusting the idle speed

Warning
Danger of accidents The engine may go out spontaneously if the idle speed is set too low.
–
Set the idle speed to the specified value. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
V00898-10
–
4
Remove guide plate
–
Position the required guide plate on the grip tube.
Guideline
The label OUTSIDE must be visible. Marking
B
positioned at marking
Grey guide plate (79002014000)
Alternative 1
Black guide plate (79002014100)
Info
The gray guide plate opens the throttle valve more
slowly.
The black guide plate opens the throttle valve more
quickly.
The gray guide plate is mounted upon delivery.
–
Clean the outside of the handlebar and the inside of the grip
tube. Mount the grip tube on the handlebar.
–
Attach the throttle cables to the guide plate and route cor-
rectly.
–
3
Position half-shells , mount and tighten screws
Guideline
Screw, throttle grip
–
1
Slide on sleeve and check the throttle grip for ease of
movement.
Finishing work
–
Check the play in the throttle cable. (
–
Run the engine until warm.
The cold start button is deactivated – A further ¼ turn
returns the cold start button back to the basic position.
( p. 22)
5
from handle tube .
A
must be
.
2
M6 5 Nm (3.7 lbf ft)
p. 124)
.