Table of Contents
Advertisement
11 TUNING THE CHASSIS
11.15
11.16
54
Handlebar position
800116-10
Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged or bent.
1
1
1
0 0 1
2
0 0 2
2
0 0 2
B00375-10
On the upper triple clamp, there are 2 holes at a distance of
to each other.
Hole distance A
15 mm (0.59 in)
The holes on the handlebar support are placed at a distance
B
of
from the center.
Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
–
1
Remove screws
. Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
2
Remove screws
. Take off the handlebar supports.
–
Place the handlebar supports in the required position. Mount
and tighten screws
2
.
Guideline
Screw, handle-
M10
bar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount screws
evenly.
Guideline
Screw, handlebar
clamp
40 Nm (29.5 lbf ft)
Loctite
1
and tighten
M8
20 Nm (14.8 lbf ft)
A
®
243™
Advertisement
Table of Contents
