Husqvarna TE 250i Owner's Manual page 79

12 SERVICE WORK ON THE CHASSIS
–
Position the fuel tank and fit the two spoilers to the sides in
front of the radiator bracket.
–
Make sure that no cables or throttle cables are trapped or
damaged.
V00928-11
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
(All EU models)
–
Position the horn with the horn bracket.
V00927-11
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
V00926-11
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using
compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
–
Lubricate the O-ring and connect plug-in connection
V00974-10 the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
1
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
2
with the collar bushings.
M6 10 Nm (7.4 lbf ft)
3
for
77