15.10
Checking the headlight setting
15.11
Adjusting the headlight range
–
Position the vehicle upright on a horizontal surface in front of
a light wall and make a mark at the height of the center of the
low beam headlight.
–
Make another mark a distance
Guideline
B
Distance
–
Position the vehicle vertically a distance
wall.
400726-10
Guideline
A
Distance
–
The rider now sits down on the motorcycle.
–
Switch on the low beam.
–
Check the headlight setting.
The boundary between light and dark must be exactly
on the lower mark for a motorcycle with driver.
»
If the light-dark border does not meet specifications:
–
Adjust the headlight range. (
Preparatory work
–
Check the headlight setting. (
Main work
–
Loosen screw
–
Adjust the headlight range by pivoting the headlight.
Guideline
The boundary between light and dark must be exactly on
the lower marking for a motorcycle with rider (instructions
on how to apply the marking: Checking the headlight set-
ting).
V00960-10
Info
If you have a payload, you may have to correct the
headlight range.
–
Tighten screw
15 ELECTRICAL SYSTEM
B
under the first mark.
5 cm (2 in)
A
5 m (16 ft)
p. 117)
p. 117)
1
.
1
.
away from the
117