Installing The Main Silencer; Changing The Glass Fiber Yarn Filling In The Main Silencer - Husqvarna TE 250i Owner's Manual

12.27

Installing the main silencer

12.28

Changing the glass fiber yarn filling in the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Over time, the fibers of the glass fiber yarn escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
12 SERVICE WORK ON THE CHASSIS
Main work
–
Mount the main silencer with the rubber sleeve
spring ring.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
V00909-10
Finishing work
–
Install the right side cover. (
Preparatory work
–
Remove the right side cover. (
–
Remove the main silencer. (
Main work
–
Remove screws
–
Pull out inner tube
–
Remove the glass fiber yarn filling
–
Clean the parts that need to be reinstalled and check for
damage.
–
Fit the new glass fiber yarn filling
–
Position outer tube
fiber yarn filling.
–
Mount and tighten screws
Guideline
Screws on the main
silencer
H01759-10
Finishing work
–
Install the main silencer. (
–
Install the right side cover. (
2
with the washers.
M6 10 Nm (7.4 lbf ft)
p. 74)
p. 74)
p. 72)
1
.
2
.
3
from the inner tube.
3
into the inner tube.
4
over the inner tube with the new glass
1
.
M5 7 Nm (5.2 lbf ft)
p. 73)
p. 74)
1
and
73