Table of Contents
Advertisement
11
SERVICE WORK ON THE CHASSIS
11.39
Checking the frame
–
Check the chain sliding piece for wear.
»
If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
»
If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
H00287-10
–
Check the chain guide with a slide gauge for dimension
Minimum thickness
guide
»
If the measured value is less than the specification:
–
Change the chain sliding piece.
402421-10
–
Check that the chain guide is firmly seated.
»
If the chain guide is loose:
–
Tighten the screws on the chain guide.
Guideline
Remaining screws, chassis
H00288-01
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracks and deformation.
»
If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame.
S00867-01
of the chain
Info
Always replace a frame that has been damaged due to a mechan-
ical impact. Repair of the frame is not authorized by Husqvarna
Motorcycles.
M8
15 Nm
(11.1 lbf ft)
.
6 mm (0.24 in)
M6
10 Nm
(7.4 lbf ft)
p. 33)
53
Advertisement
Table of Contents
