Refilling With Coolant - Husqvarna TE 250i Owner's Manual

Table of Contents

Advertisement

Warning
Danger of poisoning Coolant is toxic and a health hazard.
Keep coolant out of the reach of children.
Do not allow coolant to come into contact with the skin, the eyes and clothing.
Consult a doctor immediately if coolant is swallowed.
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
Change clothing if coolant spills onto your clothing.
16.5

Refilling with coolant

Warning
Danger of poisoning Coolant is toxic and a health hazard.
Keep coolant out of the reach of children.
Do not allow coolant to come into contact with the skin, the eyes and clothing.
Consult a doctor immediately if coolant is swallowed.
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
Position the motorcycle upright.
Place a suitable container under the water pump cover.
Remove screw
Completely drain the coolant.
Mount and tighten screw
Guideline
Screw, water pump
cover
V00964-11
Main work
Make sure that screw
Position the motorcycle upright.
V00920-10
16 COOLING SYSTEM
1
2
. Take off radiator cap
1
with a new seal ring.
M6
10 Nm (7.4 lbf ft)
1
is tightened.
.
121

Advertisement

Table of Contents
loading

This manual is also suitable for:

Te 300i

Table of Contents