Checking The Rear Brake Fluid Level - Husqvarna TE 250i Owner's Manual

13.9

Checking the rear brake fluid level

Warning
Danger of accidents An insufficient brake fluid level will cause the brake system to fail.
If the brake fluid level drops below the specified marking or the specified value, the brake system is
leaking or the brake linings are worn down.
–
Check the brake system and do not continue riding until the problem is eliminated. (Your authorized
Husqvarna Motorcycles workshop will be glad to help.)
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
–
Disconnect spring
–
4
Loosen nut
have maximum free travel.
–
To adjust the basic position of the foot brake lever individu-
ally, loosen nut
Info
The range of adjustment is limited.
–
Turn push rod
necessary, adjust the basic position of the foot brake lever.
Guideline
Free travel of foot brake
lever
–
3
Hold screw
Guideline
Nut, foot brake lever
stop
E00423-10
–
Hold push rod
Guideline
Remaining nuts,
chassis
–
Reconnect spring
–
Stand the vehicle upright.
–
Check the brake fluid level in viewer
»
If the brake fluid level has dropped below marking
–
Add rear brake fluid.
K00945-10
13 BRAKE SYSTEM
1
.
and turn it back with push rod
2 3
, and turn screw accordingly.
5
accordingly until you have free travel
3 ... 5 mm (0.12 ... 0.2 in)
2
and tighten nut .
M8 20 Nm (14.8 lbf ft)
5 4
and tighten nut .
M6 10 Nm (7.4 lbf ft)
1 .
1
.
( p. 96)
5
until you
A
. If
A
:
95