Checking Spoke Tension - Husqvarna TE 250i Owner's Manual

14 WHEELS, TIRES
14.7
106
400695-01

Checking spoke tension

Warning
Danger of accidents Incorrectly tensioned spokes impair the handling characteristic and result in
secondary damage.
The spokes break due to being overloaded if they are too tightly tensioned. If the tension in the spokes
is too low, then lateral and radial run-out will form in the wheel. Other spokes will become looser as a
result.
–
Check spoke tension regularly, and in particular on a new vehicle. (Your authorized Husqvarna
Motorcycles workshop will be glad to help.)
400694-01
–
Remove the dust cap.
–
Check the tire air pressure when the tires are cold.
Tire air pressure, off-road
front
rear
Tire air pressure, road (All EU models)
front
rear
» If the tire pressure does not meet specifications:
–
Correct the tire pressure.
–
Mount the dust cap.
–
Strike each spoke briefly using a screwdriver blade.
Info
The frequency of the sound depends on the spoke
length and spoke diameter.
If you hear different tone frequencies from different
spokes of equal length and diameter, this is an indica-
tion of different spoke tensions.
You should hear a high note.
» If the spoke tension differs:
–
Correct the spoke tension.
–
Check the spoke torque.
Guideline
Spoke nipple, front
wheel
Spoke nipple, rear
wheel
Torque wrench set (58429094000)
1.0 bar (15 psi)
1.0 bar (15 psi)
1.5 bar (22 psi)
1.5 bar (22 psi)
M4.5 6 Nm (4.4 lbf ft)
M4.5 6 Nm (4.4 lbf ft)