Regional - Cisco 8851 Administration Manual

Regional

Call Progress Tones
Parameter
Dial Tone
Outside Dial Tone
Prompt Tone
Busy Tone
Reorder Tone
Off Hook Warning Tone
Ring Back Tone
Call Waiting Tone
Confirm Tone
MWI Dial Tone
Cfwd Dial Tone
Holding Tone
Conference Tone
Secure Call Indication Tone
Page Tone
Alert Tone
Mute Tone
Unmute Tone
System Beep
Description
Prompts the user to enter a phone number.
Alternative to the Dial Tone. It prompts the user to enter an external
phone number, as opposed to an internal extension. It is triggered by a,
(comma) character encountered in the dial plan.
Prompts the user to enter a call forwarding phone number.
Played when a 486 RSC is received for an outbound call.
Played when an outbound call has failed or after the far end hangs up
during an established call. Reorder Tone is played automatically when
<Dial Tone> or any of its alternatives times out.
Played when the phone receiver has been off hook after a period of time.
Played during an outbound call when the far end is ringing.
Played when a call is waiting.
Brief tone to notify the user that the last input value has been accepted.
Played instead of the Dial Tone when there are unheard messages in
the caller's mailbox.
Played when all calls are forwarded.
Informs the local caller that the far end has placed the call on hold.
Played to all parties when a three-way conference call is in progress.
Played when a call has been successfully switched tosecure mode. It
should be played only for a short while (less than 30 seconds) and at a
reduced level (less than -19 dBm) so it does not interfere with the
conversation.
Specifies the tone transmitted when the paging feature is enabled.
Played when an alert occurs.
Played when the Mute button is pressed to mute the phone.
Played when the Mute button is pressed to unmute the phone.
Audible notification tone played when a system error occurs.
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
Cisco IP Phone Web Page
235