Rtp Parameters - Cisco 8851 Administration Manual

Cisco IP Phone Web Page
Parameter
Retry Reg RSC

RTP Parameters

Parameter
RTP Port Min
RTP Port Max
RTP Packet Size
Max RTP ICMP Err
RTCP Tx Interval
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
226
Description
Interval to wait before the phone retries registration after failing during
the last registration.
Default: Blank
For example, you can enter numeric values 500 or a combination of
numeric values plus wild cards if multiple values are possible. For the
later, you can use 5?? to represent all SIP Response messages within
the 500 range. If you want to use multiple ranges, you can add a comma
"," to delimit values of 5?? and 6??
Description
Minimum port number for RTP transmission and reception. Minimum
port number for RTP transmission and reception. Should define a range
that contains at least 10 even number ports (twice the number of lines);
for example, configure RTP port min to 16384 and RTP port max to
16538.
Default: 16384
Maximum port number for RTP transmission and reception. Should
define a range that contains at least 10 even number ports (twice the
number of lines); for example, configure RTP port min to 16384 and
RTP port max to 16538.
Default: 16538
Packet size in seconds, which can range from 0.01 to 0.13. Valid values
must be a multiple of 0.01 seconds.
Default: 0.02
Number of successive ICMP errors allowed when transmitting RTP
packets to the peer before the phone terminates the call. If value is set
to 0, the phone ignores the limit on ICMP errors.
Interval for sending out RTCP sender reports on an active connection.
It can range from 0 to 255 seconds.
Default: 0