Sd Transcode Configuration Command - Cisco D9800 Reference Manual

Transcoding Configuration Commands
If successful, the following example is the return body:
"transcode": {
}
Example 5: GET multiple HD transcoder values for a specific transcoder
The following example assumes that the user has successfully logged onto the unit, received the session id
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use. The following example retrieves multiple parameter values from
the HD transcoder settings for transcoder 5.
The user must specify the port number in the URI followed by the URI arguments the user wishes to
Note
retrieve. This example retrieves the bitratemode, bitrate and pulldown32 values from transcoder 5.
Note In GET URIs, only the index argument must contain a value for the transcoder, all other arguments do
not contain values.
curl -X GET -i
"https://192.168.0.1/ws/v2/service_cfg/transcode/hd?index=5&bitratemode&bitrate&pulldown32"
If successful, the following is an example of the return body:
"transcode": {
}

SD Transcode Configuration Command

Table 209: Command Details
Command Detail
Command URL
Command Information
HTTP Methods
Access Type
Access Level
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
248
"hd": {
"index": "5",
"bitrate": "16.0"
}
-H "Accept: application/json" -H "X-SESSION-ID: $token" -k
"hd": {
"index": "5",
"bitrate": "16.0",
"bitratemode": "CBR",
"pulldown32": "Disabled"
}
Description
https://192.168.0.1/ws/v2/service_cfg/transcode/sd
Allows set or get of SD transcode configuration.
GET, POST
Read, Write
User, Admin
API Definitions