Cisco D9800 Reference Manual page 236

Decode Configuration Commands
Command Detail
POST Syntax
Setting parameters using
command line arguments is
limited to maximum of 26
arguments after the ?.
URI Parameters (extension to the Command URL separated by /): N/A
Note
Table 186: SDIAUDIO URI Query/Set Arguments (possible fields and values preceded by ? and separated by &)
URI Argument
group (key)
slot (key)
sdiindex (key)
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
224
Description
SDI Audio:
POST
"https://192.168.0.1/ws/v2/service_cfg/decode/audio?group=1&slot=1/2&
sdiindex=1&decoder=PCM%20%Audio%201&chan=Left/Right"
SDI VANC (Vertical Ancillary Data):
POST
"https://192.168.0.1/ws/v2/service_cfg/decode/audio?serviceid=AFD&enable=Yes"
SDI VII:
POST
"https://192.168.0.1/ws/v2/service_cfg/decode/audio?sdiindex=1&enable=Enabled"
All of the URI Arguments below apply to both GET and POST except where indicated. For GET,
the URI arguments do not need any values, except the key arguments and values which must be
specified. For POST the key arguments and values must be specified followed by any of the other
URI arguments and the associated value the user would like to set. The GET result output field names
re-use the argument names and possible values. This note applies to all of Audio URI Arguments,
VANC URI Arguments, and VII URI Arguments.
Description
Audio Group
Type: Integer
Value: 1..4
Group Slot
Type: Integer
Value: 1/2, 3/4
Audio SDI Device Instance
Type: Integer
Value: 1..2
API Definitions