Cisco D9800 Reference Manual page 90

Output Status Command
Command Detail
Command Information
HTTP Method
Access Type
Access Level
Syntax for getting MOIP status output
parameters
Syntax for getting ASI status output
parameters
Table 60: URI <level_1> URI Parameters (extension to the Command URL separated by /)
URI Level 1 Parameter
asi/asi1/as2
moip/moip1/moip2
Table 61: URI <level_2> URI Parameters (extension to the Command URL separated by /)
URI Level 2 Parameter
collision
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
78
Description
This command is used to read all the ASI or MOIP DPM active
collision statuses.
Note Partial response is not supported. This command returns
the status of all active peid and row key combinations for
all output fields for the specified MOIP or ASI.
GET
Read
User, Admin
GET "https://192.168.0.1/ws/v2/status/output/moip/collision",
GET "https://192.168.0.1/ws/v2/status/output/moip1/collision", or
GET "https://192.168.0.1/ws/v2/status/output/moip2/collision"
GET "https://192.168.0.1/ws/v2/status/output/asi/collision",
GET "https://192.168.0.1/ws/v2/status/output/asi1/collision", or
GET "https://192.168.0.1/ws/v2/status/output/asi2/collision"
Description
Output type is ASI.
On NTC Basic or NTC MOIP, the supported values are asi or
asi2 for the unique asi output.
On NTC MS, the supported values are asi1 for bidirectional port
1 and asi2 for bidirectional port 2.
Output type is MOIP.
On NTC Basic, this call is not supported.
On NTC MOIP, the supported values are moip or moip1 for the
unique IP output/
On NTC MS, the supported values are moip1 for IP output 1 and
moip2 for IP output 2/
Description
DPM Active collision information.
API Definitions