Ci (Common Interface) Configuration Command - Cisco D9800 Reference Manual

API Definitions
The following example assumes that the user has successfully logged onto the unit, received the session ID,
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use. This example set the bissmode to Mode 1.
curl -X POST -i -H "Accept: application/json" -H "X-SESSION-ID:$token" -k
"https://192.168.0.1/ws/v2/service_cfg/ca/biss?&bissmode=Mode%201"
If successful, the following is an example of the return body:
"response": {
}
GET Examples:
Example 2: Retrieve the PowerVu CA Settings
The following example assumes that the user has successfully logged onto the unit, received the session ID,
and set it to the variable token. In addition, it is assumed that the IP of the unit is 192.168.0.1. You must
change the IP to the specific unit IP in use.
curl -X GET -i -H "Accept: application/json" -H "X-SESSION-ID: $token" -k
"https://192.168.0.1/ws/v2/service_cfg/ca/biss"
If successful, the following is an example of the return body:
"ca": {
}
Note The mod1seswrd, modeseswrd, and modeinjid are write-only, so their values will not be shown when
trying to perform GET. Hence, only the bissmode will provide useful information from a BISS GET.

CI (Common Interface) Configuration Command

Table 201: Command Details
Command Detail
Command URL
Command Information
HTTP Methods
Access Type
Access Level
"code": "10",
"result": "success",
"message": ""
"biss": {
"bissmode": "Mode 1",
"mod1seswrd": "************",
"modeseswrd": "****************",
"modeinjid": "**************"
}
Description
https://192.168.0.1/ws/v2/service_cfg/ca/ci
Allows set or get of Common Interface (CI) Conditional Access
configuration.
GET, POST
Read, Write
User, Admin
Cisco D9800 Network Transport Receiver Version 2.75 RESTful Web Services API Reference Guide
CA (Conditonal Access) Configuration Commands
237