Software (S/W) Download; Download Of S/W In Ebl128 (C.i.e.) - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: -
21
21.1

Software (S/W) download

The latest version of the EBL128 software
before delivery. Due to continual development and improvement,
different S/W versions can be found. EBL128 can be upgraded with a
new S/W version, downloaded on site, via EBLWin.
(current) EBL128 S/W version is shown in menu H4/U7 or via
EBLWin (Control unit pop-up menu; Software version...).

Download of S/W in EBL128 (c.i.e.)

To download new software (S/W), a PC and EBLWin are used.
Before download, the PC has to be connected to the RS232 connector
J3 in EBL128 (on the main board).
1. Start EBLWin. Do not log on to EBL128. In the "Tools" menu
select "Download Software..." to open the dialog box and do the
required settings.
2. Select the path and the S/W file to be downloaded, e.g.
English_EBL128_200.bin.
(200 = version 2.0.0)
3. Select the control unit, i.e. EBL128 (4550)
4. Select "COM Port" (on the PC) and baud rate. (If the download is
not successful it might depend on a too high baud rate.)
5. Set the control unit in "boot mode", i.e. on the main board, up to
the left, push on the jumper "JP2" (BOOT). Momentarily short
the solder pads "JP1" (RESET). The buzzer will be sounding
indicating "boot mode".
6. Start the download, i.e. click "Start". The buzzer stops sounding.
The download status is indicated in the progress bar.
"Operation" (L6) will be turned off. LED "General fault" (L7) is
63
The software (firmware) makes the microprocessor work.
75
EBL128 Operating Instructions V2.0.x
63
is factory downloaded
The valid
LED