Calibration Of Supervised Outputs (H5/A1) - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623
28.1
Action
"Access"
Scroll to menu H5.
"A"
"A"
"A"
"A"
Rev: -

Calibration of supervised outputs (H5/A1)

Supervised (monitored) outputs
- The voltage outputs (S0-S1) in the control unit
- The voltage outputs (VO0-VO1) in the COM loop output unit 3364.
- The voltage outputs (Output 0-Output 1) on the Inputs and outputs
expansion board 4583
When all alarm devices (sounders, etc.) have been connected,
including required end-of-line devices
is ready, a calibration has to be done.
Function: If the actual value differs from the calibrated value ± a
small tolerance or if the calibrated value is outside the calibration
80
range , a fault will be generated.
NOTE!
Each output's logic is programmable via EBLWin, i.e. normally low
(default) or normally high (24V) but during the calibration the outputs
will automatically be low, i.e. a normally high output will be low
during the calibration (a few seconds).
Text in display
Service
Calibration of supervised outputs
To calibrate supervised outputs
press ACCEPT
Calibration in progress
Please wait......
Calibration is completed!
78
Supervised (monitored) outputs can via EBLWin be set to be not
supervised.
79
EBL128 outputs (S0-S1) and the exp. board 4583 outputs (Output 0-
Output 1): One end-of-line resistor (33K) in the last unit or one resistor
(33K) in up to five units.
3364 outputs (VO0-VO1): One end-of-line capacitor (470 nF) in the last
unit or one capacitor (470 nF) in up to five units.
80 4K7 – 50K and 470 – 5x470 nF respectively.
EBL128 Operating Instructions V2.0.x
78
:
79
and when the SSD download
ACCEPT? H5
ACCEPT? A1
ACCEPT?
112
Comments
According to chapter
"Access", see page 81.