Technical Address / Presentation Number; Technical Address For Com Loop Units; Presentation Number - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: -
15
15.1
15.2
Technical address / Presentation
number

Technical address for COM loop units

The technical address in EBL128 is used when programming (via
EBLWin) all units connected to the COM loop.
The technical address is also used to identify which unit has generated
a fault.
The technical address is equal to the address that is set in each unit
connected to the COM loop with the Address setting tool 3314/4414.
Addresses 001 – 255 can be set (not 000).

Presentation number

For each fire alarm point / zone line input, a presentation number,
NN-NN, has to be programmed. The presentation number is shown in
the display in EBL128 and in Ext. FBP 1826 / 1828, Alert
Annunciation unit 1735 / 1736 and Ext. Presentation unit 1728, to
identify the point / zone generating a fire alarm. It is also used to
disable / re-enable fire alarm points / zones and in control conditions /
expressions to activate the programmable outputs.
Together with the presentation number, an alarm text with up to 40
alphanumeric characters can be displayed (if programmed via
EBLWin).
NN – NN
40
EBL128 Operating Instructions V2.0.x
00 – 99
01 – 99 = The Address within the zone.
00 = Zone number only will be displayed.
E.g. for one or more conventional detectors
connected to a MIO (3361) or a zone line input
(4580)
01 – 99 = Zone number