Ssd Programming & Download; Ssd Programming; Auto Generating Ssd; Ssd Download - Panasonic EBL128 Operating Instructions Manual

Panasonic Eco Solutions Nordic AB
MEW01623 Rev: -
20
20.1
20.2
20.3
SSD programming & download
The Site Specific Data (SSD) for an installation is created
(programmed) via the PC program EBLWin, which also is used to
download the SSD into the EBL128 c.i.e. and/or 1728, 1735 / 1736 &
1826 / 1828 units.
59
xxxxx.EBLWin.

SSD programming

The SSD programming can be made "in your office" and afterwards
be downloaded to EBL128 on site.

Auto generating SSD

If you are on site, the Auto generate function can be used to create
the SSD. Open a new installation in EBLWin, connect the PC to the
RS232 connector J3 in EBL128 (on the main board) and log on.
the COM loop menu select "Auto generate loop...". The COM loop
61
units connected on the COM loop will now be identified and listed
in EBLWin, i.e. the SSD will be auto generated and given default
settings (01-01, 01-02, 01-03, etc.). Save the installation (SSD). The
SSD can be downloaded to EBL128 as it is or being edited
(recommended) before the download.

SSD download

The PC with EBLWin has to be connected to the RS232 connector J3
in EBL128 (on the main board).
(xxxxx.EBLWin) and log on to EBL128.
"Download SSD..." to open the dialog box.
59
xxxxx = A suitable name of the installation.
60
An EBLWin key 5094 (a hardware key) is required, i.e. plugged in a USB
port in the PC.
61
Each unit have to be running i.e. be connected, power supplied and the
address, mode etc. have to be set. NOTE! During this check the COM loop
will be disconnected (disabled) and no alarms or faults can be activated.
Disconnected COM loop is indicated by the LED "Disablements" (L8).
72
EBL128 Operating Instructions V2.0.x
The SSD will be saved in a file named
Open the wanted installation
60
In menu "Tools" select
60
In