Siemens SENTRON Manual page 135

Note
Defined timer settings for network / generator applications
When switching from the main source to the generator, an additional delay of 5 s is set after
the generator has become available. This can be disabled with pin 414.
After return transfer to the main source, a generator cooling time is fixed at 3 mins
(command to generator remains active).
The table contains a summary of the possible potentiometer settings:
Item 0 1
no.
Un Auto 220 /
Conf 127
V
Freq.
ΔU / - 5 /
ΔF 3 %
Trans- - 0
fer
Delay/
Sec.
Return - 0
Delay/
Min.
Note
The "Ready" LED starts to flash green as soon as settings are made on the potentiometers.
Manual, 08/2017, L1V30368969104A-02
7.4 Automatic mode - programming of the electronic module (3KC8 only)
2 3 4 5
380 / 400 / 415 / 480 /
220 230 240 277
V V V V
50 Hz
6 / 7 / 8 / 9 /
3 % 4 % 4 % 5 %
1 2 3 4
1 2 3 4
6 7 8 9
208 / 220 / 230 / 240 /
120 127 132 138
V V V V
10 / 11 / 12 / 13 /
5 % 6 % 6 % 7 %
5 8 10 15
5 8 10 15
10 11 12
380 / 400 / 415 /
220 230 240
V V V
60 Hz
14 / 15 / 16 /
7 % 8 % 8 %
20 30 40
20 30 40
Operation
13 14
480 / -
277
V
18 / 20 /
9 % 10 %
50 60
50 60
135