Brush Control And Maintenance (Antea B); Brush Control And Maintenance (Antea Bt) - COMAC ANTEA 50 B Use And Maintenance Manual

1
1
Careful cleaning of the brush guarantees better cleaning of the floor
as well as a longer brush head gearmotor lifespan. To clean the
brush, proceed as follows:
1. Take the device to the dedicated maintenance area.
2. Raise the brush head unit off the floor and press the brush head
control pedal (1) on the rear of the device (Fig.1).
ATTENTION: do not lift the brush head unit completely.
3. Deactivate the vacuum motor by pressing the vacuum motor
command switch (2) on the control panel (Fig.2).
1
1
Careful cleaning of the brush guarantees better cleaning of the floor
as well as a longer brush head gearmotor lifespan. To clean the
brush, proceed as follows:
1. Take the device to the dedicated maintenance area.
2. Raise the brush head unit off the floor and press the brush head
control pedal (1) on the rear of the device (Fig.1).
ATTENTION: do not lift the brush head unit completely.
3. Press the "BRUSH UNCOUPLING" button (2) on the control
panel (Fig.2).
ATTENTION: as soon as the "BRUSH UNCOUPLING" button
(2) on the control panel is pressed (Fig.2), the control display
will show the "CONFIRM UNCOUPLING?" screen (Fig.3).
1
1
2
2

BRUSH CONTROL AND MAINTENANCE (ANTEA B)

2
2

BRUSH CONTROL AND MAINTENANCE (ANTEA BT)

2
3
4. Press the dead man's levers (3) repeatedly three times (over the
span of one minute) (Fig.3).
5. Clean the brush under running water to remove any impurities
from its bristles. Check that the bristles are not worn; in the event
of excessive wear, replace the brush (the bristles should be at
least 10 mm long). Read "ASSEMBLING THE
the brush.
ATTENTION: the place designated for this operation must
comply with current environmental protection regulations.
6. Reassemble the splash guard (read
HEAD SPLASH GUARD").
3
4. Press the "BRUSH UNCOUPLING" button (2) again to confirm.
5. Clean the brush under running water to remove any impurities
from its bristles. Check that the bristles are not worn; in the event
of excessive wear, replace the brush (the bristles should be at
least 10 mm long). Read "ASSEMBLING THE
the brush.
ATTENTION: these operations must be carried out using
protective gloves to avoid any possible contact with the edges
or tips of metal objects.
ATTENTION: the place designated for this operation must
comply with current environmental protection regulations.
3
2
50
3
4
4
BRUSH" to replace
"ASSEMBLING THE BRUSH
3
BRUSH" to replace