Installation - GE D30D00HCHF8AH6AM6BP8BX7A Instruction Manual

5 SETTINGS

PATH: SETTINGS PRODUCT SETUP
 INSTALLATION

MESSAGE
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
RELAY SETTINGS
self-test error message is displayed until the relay is put into the "Programmed" state.
UNIT NOT PROGRAMMED
The setting allows the user to uniquely identify a relay. This name will appear on generated reports.
RELAY NAME
GE Multilin


INSTALLATION

RELAY SETTINGS:
Not Programmed
RELAY NAME:
Relay-1
D30 Line Distance Protection System
5.2 PRODUCT SETUP
5.2.17 INSTALLATION
Range: Not Programmed, Programmed
Range: up to 20 alphanumeric characters
5
5-79