How To Check That Your D-Control Works Correctly; For The Best Results - Dog trace d-control easy mini Manual

How to check that your d-control works correctly

You can check anytime whether your set works correctly. Before the check, make sure that the
receiving collar is turned off.
Connect the leads of the testing discharge lamp to both contact points (loosen up the contact
points, insert the wires of the lamp under them so that
they can be firmly held and then retighten the contact
points).
Turn on your remote controller and receiver.
Press down the button for sending a stimulation
impulse. The testing discharge lamp will indicate the
receipt of the signal by a blink. The alteration of the
intensity of the pulses according to options 1 to 4 will
be indicated by a weaker or stronger light of the lamp.
At this moment, the stimulation impulse is only
indicated by the light of the test discharge lamp, i.e.
the contact points do not emit any stimulation
impulse.

For the best results

Training commands, you are sending to your dog, are transmitted from the transmitting unit to
the collar equipped with the receiver by radio waves. The propagation of radio waves is influenced
by a series of factors and under normal conditions the range of this unit is approximately
200 metres (depending on geographic conditions and surroundings).
If you want to get the best results with your unit, adhere to the following instructions:
To reach the best range for your communication, hold your remote controller in your hand and
do not cover its front part (the antenna is located there).
36
Figure indicating the test lamp
attached