How To Check That Your D-Control Works Correctly; Getting The Best Results - Dog trace d-control 502 mini User Manual

External remote control ONE TOUCH
The electronic training collars d-control 510, 910 and 1510 mini are provided
with the external remote control ONE TOUCH. It enables you to activate the
pre-set stimulation (momentary or continuous) at the receiver by a quick
pressing of one button. The button is placed at the end of a 140 cm long cable
which is connected to the transmitter (see the picture).
How to check that your d–control works correctly
You can check anytime that your d-control is operating correctly.
Before doing so, make sure that the receiver is switched off.

Place the test discharge lamp in contact with each of the

contact points as shown in the picture.
Switch on the transmitter and receiver.

Press the stimulation button and modify the level of intensity

of the stimulations: the test lamp will come on with more or less
intensity according to the selected intensity level.

Getting the best results

The training commands are transmitted to the receiver by radio waves. The range of the d-control 500,
900 and 1500 is 500, 900 or 1500 metres depending on the model and on the geographic conditions.
The transmitter range may vary depending on the way you use your transmitter, hold the transmitter
away from your body and avoid touching the front part of the transmitter where the antenna is located.
12
test discharge lamp