Table of Contents
Advertisement
CAUTION
• Take the following precautions when performing ex-
posure using this device .
– Check whether or not the patient needs extra
care before performing exposure.
– Check the patient information before performing
exposure.
• Turn the power off after finishing the work to main-
tain stable operation . If the power to the system is
kept on continuously for 24 hours out of necessity,
turn the power off and on once a week.
• To use functions that share image data, integrate the
pending reason and other settings for this device .
• Use with suitable settings for image processing pa-
rameters . To use functions that share image data,
set the same values for the image processing pa-
rameters of this device .
• Do not use devices that emit electromagnetic
waves such as mobile phones, PHS, or pocket
pagers near this device .
• Do not use continuously for extended periods of
time . If you need to use the device continuously for
extended periods, take a 10 to 15 minute break ev-
ery hour to give your eyes and hands a break .
• Take note of the reception status for radios and
TVs near this device, since interference may occur
in them when this device is in use .
• Check the touch positions on the touch panel when
starting this device, turning on the display monitor,
or unplugging and plugging in the USB cable, etc .
When the touch position and the cursor position
are out of sync, or the cursor does not move even
when touched, leave it for about two minutes, or
check the USB cable connections and restart this
device and the display monitor .
• Be sure to check the image orientation of images
received from medical imaging devices (CR, DR,
etc .) .
• Shut down this device after confirming that the
hard disk access lamp is out . Also, when turning on
again, do so after 10 seconds have elapsed .
1 .2 .3
Precautions for installing,
moving, and storing
• Take the following precautions when moving this
device .
– Do not subject to shock or vibration .
– Do not start moving until the power is turned off,
and operation has stopped completely .
– Do not move with the power cable or any other
cable connected .
• Because connections of the X-ray device can only
be made by Konica Minolta or its designated con-
tractors, contact Konica Minolta or its designated
contractors .
• Contact Konica Minolta or dealers specified by
Konica Minolta to install or move this device .
• Take note of the following when installing or storing
this device .
– Do not install or store in a location where it may
be adversely affected by atmospheric pressure,
temperature, humidity, ventilation, sunlight, dust,
salt-air, or air containing sulfur .
– Do not install or store in a location where it is not
stable, ventilation is insufficient, the difference
in light-dark is great, electromagnetic waves are
generated, or where subjected to vibration or
shock .
– Do not install or store in a location where chemi-
cal agents are used or stored .
– Do not lay this device on its back, upside down
or directly on the floor.
– Do not connect or disconnect the interface cable
while the power cable is connected .
– Do not use an interface cable other than the
specified one.
– Do not damage the interface cable . Also, do not
use damaged interface cables .
– Do not leave packing materials around .
– Do not subject this device to strong shocks or
vibration by dropping it, etc .
23
1 .2 Safety precautions
WARNING
CAUTION
Advertisement
Table of Contents
