Preparation; A) Calibrating The Print Bed - Renkforce RF100 XL Operating Instructions Manual

14. Preparation

a) Calibrating the print bed

1
• Tighten the 3 levelling screws under the print
bed as far as they will go.
3
• Go to the < ReadyPrint > menu. Select < Set >,
and then select < Levelling >.
• Touch < First >. The nozzle will move to the
first point.
• Turn the first levelling screw to control the
distance between the nozzle and print bed.
• The distance should be approximately 0.3 m
(use an A4 sheet of paper as a measurement
aid). The paper should be gently clamped so
that you feel slight resistance when moving the
paper. The nozzle must not touch the print bed!
When adjusting the print bed, always ensure that the distance between the nozzle and the print bed is the
same, otherwise the print bed will be uneven and the printed objects will not adhere properly.
If the distance between the nozzle and print bed is too small/large, repeat steps 3 and 4.
2
• Place an A4 sheet of paper between the nozzle
and the print bed to use as a measurement
guide.
4
• Repeat step 3 for the second, third, and fourth
point (calibration sequence and motion direction of
the nozzle are shown above).
29